We have been using fiberglass casting tape for our casts, which we reinforce with plaster bandage before the angle cutting process.
Has anyone had issues with heels breaking or flaking off when you are peeling casts? What things did you do to stop it from happening? Are you using a special plaster vermiculite ratio?
Also, has anyone found a separator that works for them on a consistent basis, like a special soap or silicone spray?
Thank you for your feedback!
Marc Mahler, CTO
[CTO Badge]
2650 East McDowell Road
Phoenix, Arizona 85008
602-263-1010
Fax 602-263-7473
This email, including attachments, is covered by the Electronic Communications Privacy Act, 18 USC 2510-2521, and the HIPAA privacy regulations and, as such, is confidential and may be legally privileged. It is intended for the use of the individual or entity to which it is addressed and may contain certain information that is privileged, confidential, and exempt from disclosure under applicable law. If the reader of this email is not the intended recipient or agent responsible for delivering or copying this communication and attachments, you are hereby notified that any retention, dissemination, distribution, or copying of this communication and any attachments is strictly prohibited. If you have received this communication in error, please reply to the sender that you received it in error, then delete it. Thank you for your cooperation.
