Saturday, May 18, 2024

Legacy Carver

Hewey, Bernard


I am looking for any information on operation, setup, troubleshooting, and maintenance for a 1st-generation plaster carver for prosthetic models dating back to the late 1980s/early 1990s. It was manufactured by Shape Products LTD out of Horsted Kaynes, Haywards Heath, West Sussex, England and was originally part of the Seattle Shapemaker system along with the Provel digitizer and the Shapemaker software. We recently acquired this carver and are attempting to resurrect it. Any information would be greatly appreciated. Thanks,

Bernard Hewey

Bernard Hewey, CPO| Instructor, O&P Technology

Spokane Falls Community College | MS 3190

3410 W. Ft. Wright Dr. | Spokane, WA 99224-5288

* 509 533 3733 | ? 509 533 4143
* [email protected]


Get unlimited access!

Join EDGE ADVANTAGE and unlock The O&P EDGE's vast library of archived content.


Welcome Back!

Login to your account below

Retrieve your password

Please enter your username or email address to reset your password.

The O&P EDGE Magazine
Are you sure want to unlock this post?
Unlock left : 0
Are you sure want to cancel subscription?