CADCAM CONTINUING EDUCATION COURSE
The O&P Technology Programs at Spokane Falls Community College are conducting a CADCAM Continuing Education Course on June 17, 2016 in Spokane, Washington.
The one (1) day CE course will focus exclusively on five turn-key CADCAM systems and has been approved for nine (9) CE credits by the ABC.
The five vendors will include BioSculptor, Ohio Willow Wood, Provel, TechMed3D, and Vorum. During the morning session, each vendor will offer
an interactive presentation about his/her CADCAM system and allow adequate time for shared communication. In the afternoon, each vendor
will provide five (5) one-hour hands-on demonstrations to small groups of attendees allowing everyone an opportunity to actually try out the
product with guidance provided by the vendor representative. The course will begin at 7:00 am and end at 5:30 pm with morning refreshments,
lunch, an afternoon break, and an evening reception.
REGISTRATION FEES
EARLY REGISTRATION (March 1 thru May 15) $300.00
REGISTRATION AFTER MAY 15 $375.00
REGISTRATION FOR TWO (2) or MORE $250.00 each
(from the same practice)
Registration is limited to only 40 attendees….and we’re half-way there already!
For further information and a registration form, please contact:
Ruthie H. Dearing, MHSA, JD
Program Manager
HOPE Careers Consortium Grant
Spokane Falls Community College
3410 W. Ft. George Wright Drive
Spokane, Washington 99224
509.533.3231
[email protected]
