OANDP-L
No Result
View All Result
No Result
View All Result
No Result
View All Result

Carver

Philip Brereton

Hello,

I’m looking for a clinic or fabrication facility that can carve and pull
plastic on TLSO’s and AFO’s. The scans will already be modified, and so all
that is needed is to carve, pull plastic and then ship back raw. The
trimming and finishing will be completed in the clinic.

If anyone is aware of a facility that is located on the west coast and that
can help please get in touch.

Thanks!

Regards,

Philip
philip@motionorthopedic.com
Tel: 559-273-8578

 SUBSCRIBE FOR FREE

 

O&P JOBS

Linkedin X-twitter Facebook

Get unlimited access!

Join EDGE ADVANTAGE and unlock The O&P EDGE's vast library of archived content.
SUBSCRIBE TODAY
The O&P EDGE Magazine
 
Required 'Candidate' login to applying this job. Click here to logout And try again
 
No Result
View All Result

© 2026 The O&P EDGE

Not enough quota to unlock this post
Unlock left : 0
Are you sure want to cancel subscription?
 

Account Activation

Before you can login, you must activate your account with the code sent to your email address. If you did not receive this email, please check your junk/spam folder. Click here to resend the activation email. If you entered an incorrect email address, you will need to re-register with the correct email address.

Welcome Back!

Login to your account below

Forgotten Password?

Retrieve your password

Please enter your username or email address to reset your password.

Log In
The O&P EDGE Magazine
 
Required 'Candidate' login to applying this job. Click here to logout And try again
 
No Result
View All Result

© 2026 The O&P EDGE

Not enough quota to unlock this post
Unlock left : 0
Are you sure want to cancel subscription?
 

Account Activation

Before you can login, you must activate your account with the code sent to your email address. If you did not receive this email, please check your junk/spam folder. Click here to resend the activation email. If you entered an incorrect email address, you will need to re-register with the correct email address.