Friday, April 26, 2024
OANDP-L
No Result
View All Result
No Result
View All Result
No Result
View All Result

Large bending irons

John Michael

I have been asked by a friend in Europe to see if orthotic bending irons are available in the USA with a tip opening of 9mm or 10mm. This is about 3/8 – 7/16 of an inch.

Any advice as to a source would be appreciated. The sets I have are more than 20 years old and I have no clue where I bought them back then.

–John W. Michael, CPO, FAAOP, FISPO [[email protected]]

RECENT NEWS

Get unlimited access!

Join EDGE ADVANTAGE and unlock The O&P EDGE's vast library of archived content.
SUBSCRIBE TODAY

O&P JOBS

Welcome Back!

Login to your account below

Forgotten Password?

Retrieve your password

Please enter your username or email address to reset your password.

Log In
The O&P EDGE Magazine
 
Required 'Candidate' login to applying this job. Click here to logout And try again
 
No Result
View All Result

© 2024 The O&P EDGE

Are you sure want to unlock this post?
Unlock left : 0
Are you sure want to cancel subscription?
 

Account Activation

Before you can login, you must activate your account with the code sent to your email address. If you did not receive this email, please check your junk/spam folder. Click here to resend the activation email. If you entered an incorrect email address, you will need to re-register with the correct email address.