Good morning everyone,
I was looking for some insight in regards to a CAD/CAM system for custom
orthotics. I wanted to get an opinion from users rather than from the
companies that are trying to sell me the system.A I have a couple of
questions which have been difficult to get an answer to, any insight
will be greatly appreciated it.
1. Which system do you recommend?
2. Can these systems make custom diabetic orthotics (A5513)? I assume
that I would need to add a top cover to be able to manufacture those.
3. Has anybody used them to make off the shelf orthotics and if so is it
cost effective?
We have been looking at several manufacturers, I have like (from what I
see) Sensor Medica, has anybody used them?
Your opinions will be immensely appreciate it,
Thanks everyone,
Juan Chow LO
