Dear List,
Does anyone know a technique to bevel the edge of a 9mm thick alpha?
Over the width of 1/2″, other alpha was smoothed from original thickness
to not much more than the thickness of fabric on the cut trimline.
Pat Peick, C.P.O.
603-228-1466
603-224-6031(fax)
pat@nebrace.com
www.nebrace.com
This e-mail, including attachments, is covered by the Electronic
Communications Privacy Act, 18 USC 2510-2521, & the HIPAA regulations
and, as such, is confidential & may be legally privileged. It is
intended for the use of the individual or entity to which it is
addressed & may contain certain information that is privileged,
confidential & exempt from disclosure under applicable law. If the
reader of this message is not the intended recipient or agent
responsible for delivering or copying this communication & attachments,
you are hereby notified that any retention, dissemination, distribution
or copying of any of the contents are strictly prohibited. If you have
received this communication in error, please reply to the sender & then
delete it. Thank you for your cooperation.
